Sony STR-D511 Operating Instructions - Page 10
Remote, Controls
View all Sony STR-D511 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Chapter 2 Basic Operations Remote Controls Before operating the equipments with the remote commander, be sure to set the receiver to the desired mode by pressing one of the FUNCTION buttons. The FUNCTION buttons are factory set in the following list. FUNCTION to be pressed Operating equipment DAT DAT deck CD CD player TUNER Tuner PHONO (The receiver enters the PHONO mode.) VIDEO 1 Betamax VCRs (VCR 1) VIDEO 2 LD player TAPE Tape deck A • When VIDEO 1 or 2 is pressed, the power of the selected video equipment and TV is turned on. Operating the equipment 1 Press the desired FUNCTION. 2 Press 4 (only for tape deck) or w• to start playback. Changing the Settings of the FUNCTION Buttons With the SELECT button, you can replace the functions stored in the FUNCTION buttons. To change the settings of the FUNCTION buttons 1 Press one of the FUNCTION buttons to be stored. 2 Press SELECT. 3 Press 1 to 9 button to select the desired function within 30 seconds. With the numeric buttons from 1 to 9, the each function can be selected as described below: Numeric buttons The function to be selected to be pressed 1 CD player 2 DAT deck 3 DECK A 4 DECK B 5 TV 6 LD player 7 VTR 1 8 VTR 2 9 VTR 3 To reset to the initial state, press the >10 button. Note The 0 and ENTER buttons do not function. List of operative buttons in SYSTEM mode (When setting the SYSTEWTV selector to SYSTEM) • - 2 • • . • • • . • • >310 • AfiTTIV CO DAT DECK 7V A. B • • - • • • - • • • - • • • - • • • - • • • - • • • - • • • - • . • - • • • - • • - - - - - - • - - - - --- • - - - - LDP VTR 1.2 • • • • • • • • • • • • • • • • • • • • • - • • CH PRESET • - - - • - • • - - - - _ • • • - • • • • • - • • • • - - • _ • • - - • _ - - • -- _ - • • -- • • • • - • • - - • - - - - • • • • • _ • • - - - • • • •: The button is operative. -: The button is not operative. •*: The button can operate TV. Note To operate the unit correctly, the function mode of the receiver should be same with that of the remote commander. So, be sure to press the desired FUNCTION button at first and then the operative button. 10