Sony STR-DE945 Operating Instructions - Page 5

Hooking Up the Components Antenna Hookups AM loop antenna (supplied) FM wire antenna (supplied) ANTENNA AM y COAXIAL FM 75Ω FRONT REAR L CENTER MD/DAT OUT OPTICAL MD/DAT IN TV/SAT IN DVD/LD IN COAX DVD/LD IN R SUB 5.1CH INPUT WOOFER DIGITAL CTRL S S-VIDEO CTRL S S-VIDEO S-VIDEO CTRL S IN OUT STATUS IN IN IN OUT VIDEO OUT CTRL S S-VIDEO S-VIDEO OUT OUT IN B + SPEAKERS A R L ++ + R L R L - - - - R L FRONT IMPEDANCE USE 4 - 16Ω REAR CENTER 8 - 16Ω y SIGNAL GND MONITOR VIDEO IN VIDEO IN VIDEO OUT VIDEO IN VIDEO OUT VIDEO IN CONTROL A1 AUDIO OUT SUB WOOFER FRONT 4 Ω 8 Ω IMPEDANCE SELECTOR AC OUTLET L R IN IN PHONO CD OUT IN MD/DAT OUT IN TAPE AUDIO IN AUDIO IN AUDIO OUT AUDIO IN AUDIO OUT AUDIO IN 2ND AUDIO TV/SAT DVD/LD VIDEO 2 VIDEO 1 OUT Terminals for connecting the antennas Connect the AM loop antenna FM wire antenna To the AM terminals FM 75Ω COAXIAL terminal Assembling the supplied FM antenna (Models of area code U,CA only) The supplied FM wire antenna must be connected to the supplied FM antenna adaptor. FM COAXIAL 75Ω Notes on antenna hookups • To prevent noise pickup, keep the AM loop antenna away from the receiver and other components. • Be sure to fully extend the FM wire antenna. • After connecting the FM wire antenna, keep it as horizontal as possible. z If you have poor FM reception Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna as shown below. Outdoor FM antenna Receiver ANTENNA AM y COAXIAL FM 75Ω Ground wire (not supplied) To ground Important If you connect the receiver to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe. Note Do not use the U SIGNAL GND terminal for grounding the receiver. 5