Sony STR-DH720HP Operating Instructions - Page 66
from the speakers, When a test tone is output
View all Sony STR-DH720HP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Tips • To adjust the level of all speakers at the same time, press MASTER VOL +/- or 2 +/-. You can also use MASTER VOLUME on the receiver. • The adjusted value is shown on the TV screen during adjustment. To output test tone from each speaker You can output test tone from the speakers in sequence. 1 Select "Test Tone", then press or b. 2 Adjust the parameter, then press . • OFF • AUTO: The test tone is output from each speaker in sequence. 3 Adjust the speaker level, then press . When a test tone is not output from the speakers • The speaker cords may not be connected securely. Check to see if they are connected securely and cannot be disconnected by pulling on them slightly. • The speaker cords may have short-circuit problem. When a test tone is output from a different speaker than the speaker displayed on the TV screen The speaker pattern set up is incorrect. Make sure that the speaker connections and the speaker pattern match correctly. x D.Range Comp (Dynamic range compression) Lets you compress the dynamic range of the soundtrack. This may be useful when you want to watch movies at low volumes late at night. Dynamic range compression is possible with Dolby Digital sources only. • MAX: The dynamic range is compressed dramatically. • STD: The dynamic range is compressed as intended by the recording engineer. • AUTO: The dynamic range is applied automatically with Dolby TrueHD source or other source is set to "OFF". • OFF: The dynamic range is not compressed. Tips • Dynamic range compressor lets you compress the dynamic range of the soundtrack based on the dynamic range information included in the Dolby Digital signal. • "STD" is the standard setting, and enacts light compression. Therefore, we recommend using the "MAX" setting. This greatly compresses the dynamic range and lets you view movies late at night at low volumes. Unlike analog limiters, the levels are predetermined and provide a very natural compression. x Distance Unit Lets you select the unit of measurement for setting distances. • FEET: The distance is displayed in feet. • METER: The distance is displayed in meters. 66GB