Sony STR-DH720HP Operating Instructions - Page 80
Tuner, The GUI menu does not appear on
View all Sony STR-DH720HP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
• Be sure to use a High Speed HDMI cable when you view images or listen to sound, especially for the 1080p, Deep Color (Deep Colour) or 3D transmission. No 3D image appears on the TV. • Depending on the TV or the video equipment, 3D images may not be displayed. When the receiver is in standby mode, there is no image output from the TV. • When the receiver enters into standby mode, image is from the last HDMI equipment selection before you turned off the receiver. If you are enjoying other equipment, play the equipment and perform the One-Touch Play operation, or turn on the receiver to select the HDMI equipment you want to enjoy. • Make sure "Pass Through" is set to "ON" in the HDMI Settings menu if you connect equipment not compatible with the "BRAVIA" Sync to the receiver (page 68). Recording cannot be carried out. • Check that the equipment is connected correctly. • Select the source equipment using the input buttons (page 41). The GUI menu does not appear on the TV screen. • Press GUI MODE repeatedly to select "GUI ON". If the GUI menu still does not appear on the TV screen, press MENU. • Check that the TV is connected correctly. Tuner The FM reception is poor. • Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antennas (aerial) as shown below. Outdoor FM antenna (aerial) Receiver Radio stations cannot be tuned in. • Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary. • The signal strength of the stations is too weak with automatic tuning. Use direct tuning. • Make sure you set the tuning scale correctly (when tuning in AM stations with direct tuning) (page 50). • No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations is used). Preset the stations (page 50). • Press AMP, then press DISPLAY repeatedly on the remote control so that the frequency appears on the display panel. RDS does not work.* • Make sure that you are tuned to an FM RDS station. • Select a stronger FM station. 80GB