Sony UPDR200 Operating Instructions - Page 12

Operation 7 Close the paper door, and press the center of the door until it clicks into place. Note After removing the ribbon tray, do not insert your hand into the opening in the printer. Touching the protrusions or movable parts inside the printer may result in bodily injury or malfunction of the printer. In particular, touching the thermal head when it is hot immediately after printing may result in burns. 3 Detach the white spool of the ink ribbon from the black spool. Notes • If you close the door by pressing only its sides, the door may not lock into place properly. • When closing the paper door, be sure that the front edge of the paper is not caught in the door. To load the ink ribbon 1 Pull the ribbon door toward you to open it. 4 Gently unravel the ribbon without loosening it, and place it in the ribbon tray. 2 Remove the ribbon tray. Place the white spool in the front holder and the black spool in the rear holder as shown. Note If the ink ribbon is loosely raveled around the spools or there is any slack or creases in the ink ribbon, wind the spools to tighten the slack and smooth out the creases. 12 Loading the Paper Roll and Ink Ribbon