Sony VPL ES2 User Manual - Page 18
Connecting with a VCR, Ex. VPL-ES2
UPC - 027242648760
View all Sony VPL ES2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Note To connect a Macintosh computer equipped with video output connector of a type having two rows of pins, use a commercially available plug adaptor. To connect to a video GBR/ component output connector Ex. VPL-ES2 Left side Connecting with a VCR This section describes how to connect the projector to a VCR. For more information, refer to the instruction manuals of the equipment you are connecting. To connect to a video or S video output connector Ex. VPL-CS7 Left side AUDIO AUDIO VIDEO S VIDEO INPUT A MONITOR OUT AUAUDDIIOO VIDEO S VIDEO INPUT A PR/CR PB/CB Y 32 to audio output 1 to RGB/ component output 1 2 3 to audio output to video output to S video output VCR 1Stereo audio connecting cable (not supplied) (Use a no-resistance cable) 2Video cable (not supplied) or 3S-Video cable (not supplied) 18 Connecting the Projector 15k RGB/Component equipment 1SMF-402 Signal Cable (not supplied) HD D-sub 15-pin (male) y 3 × phono plug or 2Component video (3 × phono plug y 3 × phono plug (not supplied) (Use a 75 Ω coaxial cable) (VPL-ES2 only)) 3Stereo audio connecting cable (not supplied) (Use a no-resistance cable) Notes • Set the aspect ratio using "Wide Mode" in the INPUT SETTING menu according to the input signal. • When you connect the INPUT A connector on the unit to a video GBR output connector, select "Video GBR," or when you connect it to a component output connector, select "component" with the "Input-A Signal Sel." setting in the SET SETTING menu. The input selection must be performed before inputting the signal. • Use the composite sync signal when you input the external sync signal from video GBR/component equipment.