Sony VPL ES2 User Manual - Page 7

Overview Notes on Installation and Usage Unsuitable Installation Do not install the projector in the following situations. These installations may cause a malfunction or damage to the projector. Poorly ventilated • To avoid moisture condensation, do not install the unit in a location where the temperature may rise rapidly. Subject to direct cool or warm air from an air-conditioner Installing in such a location may cause malfunction of the unit due to moisture condensation or rise in temperature. Near a heat or smoke sensor • Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on surfaces (rugs, blankets, etc.) or near materials (curtains, draperies) that may block the ventilation holes. When the internal heat builds up due to the block-up, the temperature sensor will function with the message "High temp.! Lamp off in 1 min." The power will be turned off automatically after one minute. • Leave space of more than 30 cm (11 7/8 inches) around the unit. • Be careful that the ventilation holes may inhale tininess such as a piece of paper. Highly heated and humid Malfunction of the sensor may be caused. Very dusty, extremely smoky Avoid installing the unit in a very dusty or extremely smoky environment. Otherwise, the air filter will become obstructed, and this may cause a malfunction of the unit or damage it. Dust preventing the air passing through the filter may cause a rise in the internal temperature of the unit. Clean the filter periodically. • Avoid installing the unit in a location where the temperature or humidity is very high, or temperature is very low. Notes on Installation and Usage 7