Sony ZRD-2 Operating Instructions - Page 17
Troubleshooting, Setting the Control Protocol of the, display controller
View all Sony ZRD-2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Setting the Control Protocol of the display controller Change the settings for the control protocol on the Advanced Menu. Entered values will not be applied unless you click on [Apply]. Set ADCP. ADCP Service setting area Troubleshooting Be sure to conduct a check before requesting assistance. If the problem persists, contact your local Sony representative. Checking the status of the system and devices You can check the status of the system, display controllers, display units, and other devices in the main screen. [System Status] [Array Information] ADCP button Start ADCP Service: Set ADCP to enabled or disabled. Items for ADCP are enabled only when this function is enabled. -Requires Authentication: Set the authentication for ADCP to enabled or disabled. The password is the same as that of the Web page administrator. -Port No.: Input the server port of ADCP. The factory default setting is "53595." -Timeout: Input the time (seconds) until ADCP communication is terminated in case it is disconnected. The factory default setting is "60." -Host Address: Input the IP address that the ADCP server is allowed to receive. If no IP address is input, receiving commands will be allowed from any IP address. From the moment the IP address is input, access will be allowed only from that input IP address. For security reasons, it is recommended to input an IP address to restrict access. [Controller List] [System Status] Displays the status of the system and display controllers. • [Operation Normal]: Operation is normal. • [Controller Error]: Device operation has stopped due to an error. The display controllers and display units have entered standby mode, and picture display has stopped. For details on the error, check the [Error] column under [Controller List]. • [Controller Warning]: Device operation continues but a warning (fan error, picture sync error, etc.) has occurred. Check the details of the warning, and resolve the problem as soon as possible. For details on the warning, check the [Error] column under [Controller List]. [Controller List] Displays the status of each display controller. [Power Status]: "-" indicates that communication with the display controller is not possible. [Error]: "None" indicates that there are no errors or warning. If an error or warning occurs, see "Error Codes" (page 19), and resolve the problem as soon as possible. 17