Stihl 026 Instruction Manual - Page 44

1 1 5 133BA014 KN 1 1 6 23 4 135BA032 LÄ 133BA040 KN 133BA015 KN •••• Take out the screws . Remove four screws Push the hand guard upward Pull underside of fan housing away from crankcase and remove it • downward Ease the spring clip off the • starter post. Carefully slip the washer and pawl off the starter post. Take particular care to avoid injury - the rewind spring may pop out and unwind. • Ease the cap out of the starter • grip. Remove remaining rope from the rotor and grip. Make sure the • sleeve does not slip out of the grip. Tie a simple overhand knot in the end of the new starter rope 1113 195 8200 (Ø 3,5x960) and then thread the rope through the top of the grip and the rope bush . Refit the cap in the grip. •• Pull the rope through the rotor and secure it with a simple overhand knot. • Thread the new rope 3.5 mm (9/64") dia. and 960 mm 373/4") long - through the rotor and secure it with a simple overhand knot. • Thread the other end of the rope through the guide bush (from inside) and the underside of the starter grip and secure it with a special knot - do not wind rope onto rotor.