Stihl HT 101 Instruction Manual - Page 17
the risk of the lift bucket damaging other - accessories
![]() |
View all Stihl HT 101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
N To do this, apply the cutting attachment and pull it across the bottom of the branch in an arc as far as the bar nose. N Perform the cross-cut (2) - position the bar with the hook against the branch and then perform the crosscut. Flush-cutting thick branches Cutting above obstacles A English 30° angle drive (special accessory) 1 2 390BA053 KN 390BA020 KN 4 3 If branch diameter is more than 4 in (10 cm), first N perform undercut (3) and then cross-cut at a distance of about 8 in./20 cm (A) from the final cut. Then carry out the flush-cut (4), starting with a relieving cut and finishing with a cross-cut. 390BA024 KN The unit's long reach makes it possible to prune branches that are overhanging obstacles, such as rivers or lakes. The tool angle in this case depends on the position of the branch. Cutting from a lift bucket The angle drive keeps the cutting attachment at an angle of 30° to the drive tube. The angle drive may be adjusted on the drive tube to the following positions only: 1 For cross-cutting vertical branches and bushes. 2 For a better view of the cutting attachment. 390BA058 KN The unit's long reach enables cutting to be performed next to the trunk without the risk of the lift bucket damaging other branches. The tool angle in this case depends on the position of the branch. HT 100, HT 101, HT 130, HT 131 15
![](/manual_guide/products/stihl-ht-101-instruction-manual-d53d49b/17.png)