Stihl HT 101 Instruction Manual - Page 25

English 002BA584 KN 002BA583 KN 002BA579 KN 1 N While holding the cap depressed, turn it clockwise until it engages in position. The marks on the filler cap and oil tank are then in alignment. N Fold the grip down. 002BA581 KN 002BA580 KN Filler cap is locked. If the oil level in the tank does not go down, the reason may be a fault in the oil supply system: Check chain lubrication, clean the oilways, contact your dealer for assistance if necessary STIHL recommends that you have servicing and repair work carried out exclusively by an authorized STIHL servicing dealer. If the filler cap cannot be locked in the oil tank opening Left: Right: Bottom of cap is twisted - inner mark (1) in line with outer mark. Bottom of cap in correct position - inner mark is under the grip. It is not in line with the outer mark. 002BA576 KN Bottom of cap is twisted in relation to top. N Remove the cap from the oil tank and check it from above. N Place the cap on the opening and rotate it counterclockwise until it engages the filler neck. N Continue rotating the cap counterclockwise (about a quarter turn) - this causes the bottom of the cap to be turned to the correct position. N Turn the cap clockwise and lock it in position - see section on "Closing". HT 100, HT 101, HT 130, HT 131 23