Stihl MS 210 Instruction Manual - Page 28
Mounting the Bar and Chain, quick chain tensioner
![]() |
View all Stihl MS 210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
English Mounting the Bar and Chain (quick chain tensioner) 2 3 11 2 4 Removing the chain sprocket cover 2310BA015 KN 207BA010 KN N Fit the guide bar over the studs (1) - the cutting edges on the top of the bar must point to the right. N Engage the peg of the tensioner slide in the locating hole (2) -- place the chain over the sprocket (3) at the same time. N Turn the tensioning screw (4) clockwise until there is very little chain sag on the underside of the bar - and the drive link tangs are engaged in the bar groove. N Refit the sprocket cover and screw on the nut only fingertight. N Go to chapter on "Tensioning the Saw Chain" 1 3 2 N Swing grip (1) into position (until it engages) N Turn the wing nut (2) to the left until it hangs loosely in the chain sprocket cover (3) N Remove chain sprocket cover (3) Mounting the tensioning gear 2310BA013 KN N Remove screw (2) 1 3 N Position tensioning gear (1) and guide bar (3) relative to one another 2 2310BA016 KN 2310BA017 KN 2310BA014 KN 1 N Insert and tighten screw (2) N Remove and reverse tensioning gear (1) 26 MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
![](/manual_guide/products/stihl-ms-210-instruction-manual-2375e6b/28.png)