Stihl MS 210 Instruction Manual - Page 41
with Easy2Start
![]() |
View all Stihl MS 210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Starting Standard versions N Pull the starter grip slowly with your right hand until you feel it engage - and then give it a brisk strong pull and push down the front handle at the same time. Do not pull out the starter rope to full length - it might otherwise break. Do not let the starter grip snap back. Guide it slowly back into the housing so that the starter rope can rewind properly. Machines without additional manual fuel pump: If the engine is new or after a long out-of-service period, it may be necessary to pull the starter rope several times to prime the fuel system. 143BA020 KN 135BA027 KN Models with Easy2Start The Easy2Start stores the energy required to start the saw. For this reason there may be a delay of a few seconds between cranking the engine and it actually starting. There are two ways of starting machines with Easy2Start: N Hold the starter grip with your right hand and pull it out slowly and steadily - or - hold the starter grip with your right hand and give it several short pulls, using only a short length of rope for each pull. N Push down the handle while cranking. Do not pull out the rope to its full length - it might otherwise break. N Do not let the starter grip snap back. Guide it slowly back into the housing so that the starter rope can rewind properly. Starting the saw WARNING Bystanders must be well clear of the general work area of the saw. N Observe safety precautions. English Versions with manual fuel pump N Press the fuel pump bulb at least five times - even if the bulb is already filled with fuel. MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C 39
![](/manual_guide/products/stihl-ms-210-instruction-manual-2375e6b/41.png)