Symphonic SC3809 Owner's Manual - Page 27
Troubleshooting, Guide
View all Symphonic SC3809 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
TROUBLESHOOTING GUIDE If you have followed the instructions contained in this manual and have difficulty in operating your TV/VCR, locate the SYMPTOM in the left column below. Check the corresponding POSSIBLE CAUSE and CORRECTIVE ACTION columns to remedy the problem. SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION No power • AC Power cord is not connected. • Connect AC power cord to AC outlet. • DC battery car cord is not connected • Connect battery cord to vehicle's while TVNCR is installed in cigarette lighter socket and to DC 13.2V vehicle. jack on back of TVNCR. • Fuse in car battery cord is blown. • Replace with 5A, 250V fuse. • POWER button is set to OFF. • Set the POWER button to ON. No picture and sound. • TVNCR is not plugged into an • Plug power cord into an active AC outlet. active AC outlet. • Antenna is not connected. • Check antenna connection. • No channel in memory. • Program tuner's memory. No picture or poor pic- • Direction or condition of antenna is • Adjust direction or replace antenna. ture on TV/VCR. not adequate. • Picture control is not adequate. • Adjust picture controls. No sound or poor sound. • Volume control on remote control • Adjust volume control on remote control unit or main unit is in minimum unit or set. position. • MUTE button on the remote control • Press MUTE button. unit is in the ON position. Timer recording is not • The timer recording is set incorrectly. • Set the timer recording correctly. possible. • The timer recording is not set to ON. • Set the timer recording to ON. Cannot go into Record • The erase-prevention tab on cassette • Place transparent tape over missing mode. is missing. erase-prevention tab. Playback picture is par- • The tracking control is not set • Adjust tracking control for better picture. tially noisy. correctly. No picture but the audio • Video heads are dirty. is OK in playback. • I-lead cleaning is necessary, consult the nearest Service Center. No operation by infrared • No power to TVNCR. Remote Control. • Make sure the AC cord is connected to an AC outlet. • Weak batteries. • Check the batteries in infrared Remote Control. Video or color fades in • You are copying a copyrighted video • None. and out when making a tape and are experiencing copy guard copy of a video tape. protection. Cannot set the auto clock • DC battery car cord is connected to • Connect AC power cord to AC outlet to ON. the DC13.2 V jack. - 27 - EN 8B26