Symphonic SC724FDF Owner's Manual - Page 17

CHANNEL SET UP Make sure ... • The unit must be turned on. TV/VCR AUTO CHANNEL PROGRAMMING As the initial setting, this unit has memorized all channels, including the ones not available in your area. This feature automatically puts only available channels into the memory. 1 Select "CHANNEL SET UP" Hit [SETUP]. Press [K / L] to point to "CHANNEL SET UP", then hit [ENTER]. - TV/VCR SETUP - TIMER PROGRAMMING SETTING CLOCK B CHANNEL SET UP USER'S SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF] ZERO RETURN TIME SEARCH INDEX SEARCH 2 Begin channel scanning Press [K / L] to point to "AUTO CH PROGRAMMING", then hit [ENTER]. The tuner scans and memorizes all the active channels in your area. - CHANNEL SET UP - ADD / DELETE CH (CATV) B AUTO CH PROGRAMMING 3 After scanning The tuner stops on the lowest memorized channel. NOTES: • When "AUTO CH PROGRAM- MING" is activated where there is no TV signal input, "NO TV NO TV SIGNALS SIGNALS" will appear on the display after the completion of channel scanning. • The unit may recognize CATV channels to be TV channels if reception condition is poor. In this case, check the antenna connection and try "AUTO CH PROGRAMMING" again when reception condi- tions are better. • Channel memory programming is NOT neces- sary when connected to a cable box or satellite box. Just select the channel for cable box or satellite input (ex. CH3) on the unit, then select your desired channel on the cable box or satel- lite box. ADDING/DELETING CHANNELS The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.) 1 Select "CHANNEL SET UP" Hit [SETUP]. Press [K / L] to point to "CHANNEL SET UP", then hit [ENTER]. - TV/VCR SETUP - TIMER PROGRAMMING SETTING CLOCK B CHANNEL SET UP USER'S SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF] ZERO RETURN TIME SEARCH INDEX SEARCH 2 Select "ADD/DELETE CH" Press [K / L] to point to "ADD/DELETE CH", then hit [ENTER]. - CHANNEL SET UP - B ADD / DELETE CH (CATV) AUTO CH PROGRAMMING 3 Enter the desired channel number Press [CH. K / L] or the Number buttons until your desired channel number appears. (You can also 08 press [K / L] to enter it.) • You must precede single-digit channel numbers with a zero (Example: 02 ... 09). ADD / DELETE (Example: CH8) • When selecting cable channels which are higher than 99, hit [+100] first, then press the last two digits. (Example: to select channel 125, first hit [+100] then hit [2] and [5].) 4 Delete (or add) it from (or into) memory Hit [ENTER]. The channel number changes to light red. The channel is deleted from memory. • To delete another channel, repeat steps 3 to 4. • If you hit [ENTER] again, the channel is memo- rized again. Added channel : Light blue Deleted channel : Light red 5 Exit the channel setup mode Hit [SETUP] to exit the menu. NOTE: • To confirm that channel(s) has been deleted or added, press [CH. K / L]. - 17 - EN