Symphonic TR-WF13 Owners Manual - Page 10

PREPARATION FOR USE ANTENNA/CABLE CONNECTIONS VHF/UHF SEPARATE A NTENNA S In some areas it will be necessary to use an outdoor antenna. VHF/U111: Cal-MINED ANTENNA The VHF/UHF Rod Antenna (supplied) is detachable. Insert the stem of the antenna into the hole on the upper-back portion of the TVNCR. Connect the VHF/UHF Rod Antenna or VHF/UHF Combination Antenna to the ANT. terminal of the TV/VCR at, shown in the diagram below. For the best reception. fully extend the VHF/UHF Rod Antenna and make the necessary adjustments. (Avoid touching the top section when adjusting.) VHF Antenna UHF Antenna VHF/UHF 0 Combiner Ile (Not O supplied) NOTE : Before plugging the Rod antenna into antenna terminal, check that the pin is not bent. If it is bent. straighten the pin as illustrated, then plug the pin into antenna terminal. Bent pin Cable Plug (Needs to be straightened) (Straight pin) VHF/UHF Antenna Rod Antenna (Supplied) et' ANT. I © 1 0 Flat twin-lead cable[Fig5] CABLE 147THOL T CO; IERTER/ DESCRAMBLER BOX Use this connection if your cable system connects directly to your TVNCR without a converter box. By using this connection you can: 1) Use the TVNCR remote to select channels 2) Program one or more unscrambled channels for Automatic Timer Recording.. NOTE: This unit will ONLY record and view the same channel. From Cable System I75-ohm Coaxial Cable (not supplied) ur ANT. :t [Fig.4] NOTE: The connection of an indoor antenna may not always give acceptable TV reception. 0 [Fig.SJ Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. Antenna/Cable Connections Continued on the Next Page. - I0- EN 7103