TASCAM DM-24 Application-Specific Documents DM-24 as a Live Mixer - Page 5

CU/PWSPLIT TDIF SPLITTER Y CABLE, This is a TDIF Splitter Y cable. The Y splits

Get TASCAM DM-24 PDF manuals and user guides View all TASCAM DM-24 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

The I/O screen shot below shows buss 1-8 outputs feeding all of the TDIF, ADAT and OPTION SLOT outputs. Outputs are always active, but inputs have to be chosen. As we're already using ADAT 1-8 inputs for our 1st DigimaxLT on channels 17-24 and the SLOT 1-8 inputs for our 2nd DigimaxLT inputs on channels 25-32, we're going to use TDIF2 1-8 to send and return our buss 1-8 signal. This requires two cables. One CU/PWSPLIT. This is a TDIF Splitter Y cable. The Y splits the INPUT and OUTPUT section of the TDIF cable. The standard end plugs in to the TDIF 2 jack on the DM-24. Now use a CU/PW88DS, which is a 2' TDIF cable, and plug one side of the cable in to the OUTPUT side of the Y cable and the other end of the TDIF cable into the INPUT side of the Y cable. Basically we just plugged the OUTPUT of TDIF 2 in to the INPUT of TDIF2. So the buss 1-8 signal is being routed to the TDIF2 1-8 RETURN, which is coming back on the Aux 1-2 path and then being assigned to the stereo buss. The RETURN source for CH 9-16 must be set to B:TDIF2 even though channels 9-16 are using the Mic/line inputs. CU/PWSPLIT TDIF SPLITTER Y CABLE

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
The I/O screen shot below shows buss 1-8 outputs feeding all of the TDIF, ADAT and OPTION
SLOT outputs.
Outputs are always active, but inputs have to be chosen.
As we’re already using
ADAT 1-8 inputs for our 1st DigimaxLT on channels 17-24 and the SLOT 1-8 inputs for our 2
nd
DigimaxLT inputs on channels 25-32, we’re going to use TDIF2 1-8 to send and return our buss
1-8 signal.
This requires two cables.
One CU/PWSPLIT.
This is a TDIF Splitter Y cable. The Y splits the
INPUT and OUTPUT section of the TDIF cable. The standard end plugs in to the TDIF 2 jack on
the DM-24.
Now use a CU/PW88DS, which is a 2’ TDIF cable, and plug one side of the cable in
to the OUTPUT side of the Y cable and the other end of the TDIF cable into the INPUT side of the
Y cable.
Basically we just plugged the OUTPUT of TDIF 2 in to the INPUT of TDIF2.
So the
buss 1-8 signal is being routed to the TDIF2 1-8 RETURN, which is coming back on the Aux 1-2
path and then being assigned to the stereo buss. The RETURN source for CH 9-16 must be set
to B:TDIF2 even though channels 9-16 are using the Mic/line inputs.
CU/PWSPLIT TDIF SPLITTER Y CABLE