TEAC CD-RW901SL CD-RW901SL Owner's Manual - Page 20

4IM−PPOlaRyTAbaNcTkSoApFeErTaYtiPoRnEsCAUTIONS Single-track playback This function enables playback of just a single track. 1. When stopped, set the mode to display Single or Mode>Single. 2. Use the SKIP keys or the number keys (0~9) on the remote control to select the desired track. The MULTI JOG dial can be used to select the track also. Random playback In this mode, the unit will play back all the tracks on the disc in completely random order, regardless of track number. When stopped, set the mode to display Random or Mode>Random. Press the PLAY key and random playback will begin. Program playback This function enables playback of selected tracks in any desired order. Up to 99 tracks can be selected for program playback. 1. When stopped, set the mode to display Program or Mode>Program. 2. Use the number keys (0~9) on the remote control unit to select each desired track for program playback, then press the ENTER key. You can also rotate the MULTI JOG dial to select the track number and push to enter. The track number will be entered into the program. Repeat the above step 2 until the desired program is completed. As the program is being created, the program number and total program playing time is revised on the display. NOTE If the CLEAR key is pressed, the programmed track will be deleted from the last. 3. Press the PLAY key to begin playback. After the selected track finishes, playback stops. NOTE Even when the power is turned off, the unit will remain in Random mode. 3. When program setting is completed, press the PLAY key to begin playback of the tracks in the programmed order. NOTE If the STOP key is pressed without first pressing the PLAY key, all the program data will be erased. When stopped, if the playback mode is switched to another, all the program data will be erased. The programmed play order is not memorized when power is turned off. In this mode, if there are no tracks programed, the CD-RW901SL will not start playback. If an attempt is made to enter more than 100 program steps, the message PGM Full! appears on the display. If the total program playing time exceeds 999 min 59 sec, --- : -- appears on the display. Time display switching When the TIME key on the front panel or the remote control is pressed, the time display will switch through several modes on the display. • Elapsed track time (no display light indication) • Remaining track time (REMAIN is lit in the display) • Elapsed disc time (TOTAL is lit in the display) • Remaining disc time (TOTAL and REMAIN are lit in the display) When stopped, the total recording time is shown, regardless of the status of the TOTAL and REMAIN indicators. NOTE In program mode, pressing the TIME key displays the elapsed and the remaining time of the whole program. 20 TASCAM CD-RW901SL When playing an MP3 disc, elapsed track time is always displayed, and the TIME key cannot be used. For details on time display during recording, please refer to "Time display while recording" on page 27. Even when power is turned off, the time display mode setting is retained.