TEAC CD-RW901SL CD-RW901SL Owner's Manual - Page 9
Connections
View all TEAC CD-RW901SL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
IMPORTANT SAFETY1 −INISnTtRroUdCuTIcOtiNoSn Beware of condensation If the unit (or a compact disc) is moved from a cold to a warm place, or used after a sudden temperature change, there is a danger of condensation; vapor in the air could condense on the internal mechanism, making correct oper- Connections The following should be noted when you connect the unit to other equipment. It is possible to connect the unit's DIGITAL COAXIAL IN, DIGITAL OPTICAL IN, DIGITAL IN (AES/EBU), and balanced or unbalanced ANALOG INs (L, R) to other equipment at the same time. However, the unit can receive signals from only one digital input at a time. Currently selected input jack is shown on the display. ation impossible. To prevent this, or if this occurs, let the player sit for one or two hours at the new room temperature before using. Audio signals output from the unit are output from the balanced or unbalanced ANALOG OUT jacks, as well as from the DIGITAL COAXIAL OUT, DIGITAL OPTICAL OUT and DIGITAL OUT (AES/EBU) connector simultaneously (but not from the digital outputs in stop mode). Currently selected input jack is shown on the display. Control connections The pinouts of the CONTROL I/O (parallel) terminal on the rear panel (see "Rear panel" on page 11) are: Pin Function 1 STOP TALLY OUT 2 REC TALLY OUT 3 SKIP (forward) IN 4 SKIP (back) IN 5 EOM TALLY OUT 6 REC IN 7 CALL IN 8 GND 9 PLAY TALLY OUT 10 READY TALLY OUT 11 FADER START/STOP 12 STOP IN 13 PLAY IN 14 READY IN 15 +5V a a: The maximum current supplied from this terminal is 50 mA. Tall signals are open collector, with a maximum current of 50 mA. Input signals are active when low (ground) for ≥ 30 ms. A fader start/stop control should be wired according to the following schematic: 4501 1JO(/% 45"35 1JO '"%&345"354501 TASCAM CD-RW901SL