TEAC CD-RW901SL CD-RW901SL Owner's Manual - Page 29
Automatic track division
View all TEAC CD-RW901SL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
IMPORTANT SAFETY IN5S−TRUecCoTrIOdiNnSg NOTE If you set the value so that only high-level signals trigger recording, remember that the start of a piece may not be record as in the diagram. level S_LVL Recordsing starts This part of the track may not be recorded time Sync recording with trim function This Sync trim function allows you to override the automatic sync recording where necessary, to chang the start time of the track forwards or backwards. Use the SYNC TRIM option in the REC sub-menu to turn the function on (see "Operation basics" on page 16). Also remember that when recording from an analog source, the threshold should be set so that it is higher than the "noise floor". If the "noise floor" is higher than the threshold, a false start will occur: level Start of track is not registered S_LVL Noise is higher than threshold time The available trim range is from -125 through +125 frames. Turn the MULTI JOG dial to adjust the trim value. Automatic track division The trigger level can also be used to divide tracks if the A_TRACK (auto track) function is enabled. When this function is enabled, the unit automatically inserts a track division in the recorded material. ª To enable or disable automatic track division: 1. Use A_TRK option in the REC sub-menu to set the mode on. The A.TRACK indicator at the top right of the display lights. 2. Rotate and push the MULTI JOG dial to select and enter the modes following: DD (digital direct) When recording digitally from MD, CD or DAT, this mode detects a track boundary and divides the track. However, when the DD mode is on, and if the analog source or non-DAT/CD/MD digital connections are detected, the track number will be incremented using level detection, as set with the A_TRK LEVEL setting as described here. When AES/EBU is selected, this mode cannot be used. Time (Time track increment) The track will be incremented when the time set prior to recording using the menu item "A_TRK TIME?" has passed (see "Operation basics" on page 16). The time can be set between one minute and ten minutes in one minute increments. The A.TRACK indicator blinks during recording or when in record ready mode. This function can be turned on by pressing the AUTO TRACK key on the remote control. Level When the sound level has dropped below the threshold for more than two seconds, and sound has re-started, the track will be divided. Use A_TRK LEVEL option in the REC sub-menu. The trigger level is set to -24dB to -72 dB. At least level 2 seconds Track increment A_LVL time 29 TASCAM CD-RW901SL