TP-Link 9dBi CPE510 V1 QIG - Page 14

2. Configuration for Typical Applications This section introduces the configurations for the point-to-point, point-to-multipoint and hotspot applications. Refer to the section corresponding to your networking needs. • Point-to-Point Point-to-Point application is used to build a transparent bridge between two locations which are far from each other. The figure shown below is an example for this application. Computer Access Point LAN: 192.168.0.254 Client LAN: 192.168.0.2 IP camera Refer to the following steps to configure the CPEs. Configure the Access Point 1. Log in to PharOS 2. Go to the Quick Setup page 3. Operation Mode • Select 'Access Point'. • Click 'Next'. 4. LAN Settings: Click 'Next'. 5. Wireless AP Settings • SSID: customize the name for the network as you like. • Security: select 'WPA-PSK/WPA2-PSK'. • PSK Password: create the password for the network as you like. • Distance Setting: enter the distance between the Access Point and the Client. It is recommended to round the number up to the nearest integer. • Select the MAXtream option if the Access Point and the Client both are Pharos outdoor CPEs. (Refer to 'Q4' in 'FAQ' for details about MAXtream) • Click 'Next'. 6. Finsh: Click 'Finish'. 11