TP-Link T2600G-18TSTL-SG3216 T2600G-18TSUN V1 Instalation Guide - Page 8
SFP Port
View all TP-Link T2600G-18TSTL-SG3216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
JetStream Gigabit L2 Managed Switch SFP Port Designed to install the SFP module. T2600G-52TS features 4 individual SFP ports and supports 1000M SFP module connection only. The front panel of The T2600G-28MPS is shown as the following figure. Figure 1-4 Front Panel of T2600G-28MPS LEDs Console Console (RJ45) (USB) 10/100/1000Mbps RJ45 Port SFP Port T2600G-28MPS has an LED mode switch button which is for switching the LED status indication. When the Speed LED is on, the port LED is indicating the data transmission rate. When the PoE LED is on, the port LED is indicating the power supply status. By default the Speed LED is on. Pressing the mode switch button, the Speed LED will turn off and the PoE LED will light up. Then the PoE LED will turn off after being on for 60 seconds and the Speed LED will light up again. When the Speed LED is on, the port LED is indicating the data transmission status. LEDs LED Status Indication On The switch is powered on. PWR Off The switch is powered off or power supply is abnormal. Flashing Power supply is abnormal. Flashing SYS On/Off The switch works properly. The switch works improperly. Green All the fans work properly. FAN Yellow Not all the fans work properly. Off The switch works improperly. Speed or PoE (Port 1-24) Green Yellow On Flashing On Flashing A 1000Mbps device is linked to the corresponding port, but no activity. A 1000Mbps device is linked to the corresponding port and data is being transmitted or received. A 10/100Mbps device is linked to the corresponding port, but no activity. A 10/100Mbps device is linked to the corresponding port and data is being transmitted or received. Off No device is linked to the corresponding SFP port but no activity. 1000Base-X (Port 25-28) On Flashing Off There is a device linked to the corresponding port. The corresponding SFP port is transmitting or receiving data. There is no device linked to the corresponding SFP port. When the PoE LED is on, the port LED is indicating the power supply status. 04 Introduction