Thermador PRD486EDG Installation Instructions - Page 14
and 36 Inch Ranges s 7A and 7B - parts
View all Thermador PRD486EDG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Step 4: Installing Anti-Tip Device 30 and 36 Inch Ranges (Figures 7A and 7B) Thermador Service Part No. Qty 415078 4 487310 1 Description Screw, Phillips, #10 x 1-1/2" Anti-Tip Bracket, Floor-Mounted IMPORTANT INSTALLATION INFORMATION: • The anti-tip bracket may be attached to a solid wood cabinet having a minimum wall thickness of 3/4". • The thickness of the wall or floor may require use of longer screws, available at your local hardware store. • In all cases, at least two (2) of the bracket mounting screws must be fastened to solid wood or metal. • Use appropriate anchors when fastening the mounting bracket to any material other than hardwood or metal. • Prepare holes at fastener locations as identified below: - For walls, wall studs, or floors composed of solid wood or metal, drill 1/8" pilot holes. FIG. 7A - Mounting Anti-tip Bracket - For walls or floors composed of drywall, sheet-rock or other soft materials, drill 3/16" holes to a minimum depth of 1-3/4", then tap plastic anchors into each of the holes using a hammer. - For walls or floors composed of concrete or concrete block, drill 3/16" holes to a minimum depth of 1-3/4", then tap concrete anchors into each of the holes using a hammer. - For walls or floors having ceramic tile covering, drill 3/16" holes through the tile only, then drill into the material behind the tile as indicated immediately above. • If the range is moved to a new location, the AntiTip Device must be removed and reinstalled. MOUNTING ANTI-TIP BRACKET The alternative floor mounted bracket shall be installed as follows: a) Place bracket on floor in position shown in Figure 7B. b) Secure to floor or wall stud. c) Later, when the unit is installed, the adjustable leg will slide under the bracket. FIG. 7B ® 2-1/2" from edge of range ® ® ® 2-1/2" (typical either side) 11