Thermador PRG366EG Installation Instructions - Page 13

Step 4: Installing Anti-Tip Device For all 30" and 36" ranges, an anti-tip device must be installed as per these instructions. WARNING RANGE TIPPING HAZARD • All ranges can tip and injury can result. To prevent accidental tipping of the range, attach it to the floor, wall or cabinet by installing the Anti-Tip Device supplied. • A risk of tip-over may exist if the appliance is not installed in accordance with these instructions. • If the range is pulled away from the wall for cleaning, service or any other reason, ensure that the Anti-Tip Device is properly reengaged when the range is pushed back against the wall. In the event of abnormal usage (such as a person standing, sitting, or leaning on an open door), failure to take this precaution can result in tipping of the range. Personal injury might result from spilled hot liquids or from the range itself. WARNING • ALL RANGES CAN TIP • INJURY TO PERSONS COULD RESULT • INSTALL ANTI-TIP DEVICES PACKED WITH RANGE • SEE INSTALLATION INSTRUCTIONS WARNING ELECTRICAL SHOCK HAZARD • Use extreme caution when drilling holes into the wall or floor. There may be concealed electrical wires located behind the wall or under the floor. • Identify the electrical circuits that could be affected by the installation of the AntiTip Device, then turn off power to these circuits. • Failure to follow these instructions may result in electrical shock or other personal injury. ATTENTION PROPERTY DAMAGE • Contact a qualified installer or contractor to determine the proper method for drilling holes through the wall or floor material (such as ceramic tile, hardwood, etc.) • Do not slide the range across an unprotected floor. • Failure to follow these instructions may result in damage to wall or floor coverings. Tools Needed for Installation of Anti-Tip Device: • Screwdriver, Phillips • Hammer • Drill, electric or hand • Pencil or other marker • Measuring tape or ruler • 1/8" drill bit (wood or metal wall or floor) • 3/16" carbide-tipped masonry drill bit (concrete or concrete block wall or floor) • 3/16" anchors, drywall or concrete, 4 each (not required if mounting bracket is being attached to solid wood or metal) 10