Toshiba 34HD82 Owners Manual - Page 16
Programming for Use with a Non-Toshiba VCR or Cable TV Converter
View all Toshiba 34HD82 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Introduction Connecting your TV Using the Remote Control (Continued from previous page) To control a cable TV converter: 1. Program the remote control to recognize your converter brand. 2. Set the TV/CABLE/VCR switch to the CABLE position. The shaded buttons shown at right will then control the cable TV converter. Programming the remote control for use with a non-Toshiba VCR or cable TV converter This remote control is pre-programmed to operate Toshiba VCRs. To use VCRs or cable converters other than Toshiba models, you must follow the steps below before you operate your remote control. 1. Refer to the VCR and cable TV converter code tables on pages 17 and 18 to find the code for your VCR or converter brand. If more than one code is listed, try each one separately until you find one that works. 2. If you are reprogramming the remote control to operate your: • VCR-set the TV/CABLE/VCR switch on the remote control to VCR. • Cable TV converter-set the TV/CABLE/VCR switch on the remote control to CABLE. 3. While holding down the RECALL button, press the Channel Number buttons (0-9) to enter the three-digit code for your VCR or converter brand. 4. Point the remote control at the VCR or converter and press POWER to test the code. If the VCR or converter turns on, you have entered the correct code. If the VCR or converter does not respond to the remote control, you may have entered the wrong code. Repeat steps 1-4 using another code. 5. Reset the TV/CABLE/VCR switch to "TV" to control the TV. LIGHT RECALL POWER TV CABLE VCR MUTE TV/VIDEO TIMER 123 CH 456 789 CH RTN VOL 100 0 ENT ADV/ POP CH RECALL POWER Channel yz Channel Number Enter FAVORITE EXIT PIC SIZE FAV MENU/ ENTER FAV C.CAPT ADV/ POP CH STOP SOURCE PLAY PIP Note: • Each time you replace the batteries, you must reprogram the remote control. • Some newer VCRs are capable of working on either of two remote codes. These VCRs have a switch labeled "VCR1/VCR2." If your VCR has this kind of switch and does not respond to any of the codes for your VCR brand, set the switch to the other position (VCR1 or VCR2) and reprogram the remote control. For future reference, write down the codes you used: VCR code: Cable TV converter code Setting up your TV Using the TV's Features Appendix Index 16