Toshiba SD-M1212 Product Specification - Page 3
When this product is incorporated into an equipment by using the mounting screw hole in
View all Toshiba SD-M1212 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
11. As for mounting bracket to incorporate this product into an equipment, (1) When this product is incorporated into an equipment by using the mounting screw holes in the right and left side planes, the clearance between this product and the mounting bracket is too wide; (2) When this product is incorporated into an equipment by using the mounting screw hole in the bottom, the surface of the mounting bracket is contorted. If you use such mounting bracket as the above, this product will become deformed, which may cause operation failure. Therefore, it is necessary to take account of the mounting bracket which has the tolerances shown in Fig.1 or whose structure cannot cause this product to deform, as shown in Fig.2 146+/-0.3 less than plane 0.5 146.3+ 0.2 - 0 Fig.1 Select screws, the length of which threaded onto the product is within 3 +/- 0.5 mm When a large amount space is left, insert spacers, etc. to adjust the space less than 0.5 mm between the product and mounting bracket. this product this product before the fixing Fig.2 mounting bracket after the fixing SD-M1212 Rev.1.0