Toshiba SD-V290 Owners Manual - Page 11
Preparations, Connections, Antenna/Cable TV to DVD+VCR - instruction manual
View all Toshiba SD-V290 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
PREPARATION Connections Tips z Depending on your TV and other equipment you wish to connect, there are various ways you could connect the DVD+VCR. Use connections described on pages 11-14. z Please refer to the manuals of your TV, VCR, Stereo System or other devices as necessary to make the best connections. z For better sound reproduction, connect the DVD+VCR's DVD/VHS AUDIO OUT jack to the audio in jacks of your amplifier, receiver, stereo or audio/video equipment. See Optional, Preferred TV Connections on page 13-14. Caution z Make sure the DVD+VCR is connected directly to the TV. Tune the TV to the correct video input channel. z Do not connect the DVD+VCR's DVD/VHS AUDIO OUT jack to the phono in jack (record deck) of your audio system. z Do not connect your DVD+VCR via your VCR. The DVD image could be distorted by the copy protection system. Connecting Antenna/Cable TV to DVD+VCR 1 Disconnect the antenna leads from the rear of the TV. 2 Identify the type of cable from your antenna. If it is a round cable as illustrated, it is a 75 ohm coaxial antenna cable. This cable will connect directly to the jack marked ANT.IN on your DVD+VCR. Without Cable Box If your cable wire is connected to your TV without a converter or descrambler box, unscrew the wire from your TV and attach it to the ANT.IN jack on the DVD+VCR. Use the supplied round coaxial cable to connect between the DVD+VCR's RF.OUT jack and the 75 ohm antenna input jack on the TV. With this connection, you can receive all midband, super band, and hyperband channels. With Cable Box If a converter is required in your cable system, follow the instruction below: The cable hookup permits both TV and DVD+VCR operation. To view or record CATV channel 1 Tune the TV to the DVD+VCR output channel (CH 3 or 4). 2 Set the DVD+VCR channel selector to the output channel of the Cable Converter box by pressing the CH/TRK (+/-) or number (0-9) of your DVD+VCR. (Example: CH3) 3 Select the channel to view at the Cable Converter Box. Notes z With this connection, you CANNOT record one program while viewing another. z If you are using a cable box to tune channels, it is not nec- essary to do Auto Channel Programming(Auto Channel Set) as indicated on page 16. Back Panel of Typical Cable Box Cable TV Wall Jack Tip If your antenna lead wire is a flat type antenna cable, connect it to a Antenna Adaptor (300-ohm to 75-ohm) (not supplied) and slip the Adaptor onto the ANT.IN jack. The Adaptor does not screw on to the DVD+VCR, it just slips over the jack. Antenna Flat Wire (300 ohm) Antenna Cable TV Wall Jack 300/75 ohm OR OR Adaptor (Not supplied) Rear of DVD+VCR Rear of DVD+VCR 1-13