Toshiba TDP-TW90A Owners Manual - Page 21

Setting up the wireless LAN (Continued) • Subnet mask A subnet mask is used to determine what subnet the IP address assigned to a terminal belongs to. (Example: 255.255.xxx.xxx) • Gateway This value specifies the device, such as a router, to be used to access servers outside the network. It is identified by the IP address. (Example: 111.112.xxx.xxx) • [Setting initialization] This item resets the wireless LAN settings to their factory defaults. • [Projector name] This can be used to identify projectors when communicating with multiple projectors, or if there is a possibility that another person who is out of communication range will be using the same projector. It is recommended this is set to prevent wrong transmission. • [Other] This item is expanded into the following items: Item Description Remote control Select whether this projector is to be remote-controlled by the computer. Allowed Presentation Forbidden Allowed : Always accepts remote commands from the computer. Presentation : Accepts remote commands only from the computer, the screen of which is currently being displayed via the projector by the Wireless Utility (Update automatically). Forbidden : Always ignores remote commands from the computer. Browser Enable or disable password authentication for access to the setting authentication menu of the Projector Configuration Tool. On Off Password Set the password to be made valid for access to the setting menu when [Browser authentication] is set to [On]. Specify a string of arbitrary characters (1 to 8 characters). [ : Enter the setting mode] [ : Move from digit to digit] [ to : Enter the string] [Accept: ] Status Select whether to automatically send error information to a specified notification e-mail address if an error occurs, for example, when the lamp has blown. On Off SMTP server Set the IP address of the SMTP server. [ : Enter the setting mode] [ : Move from digit to digit] [ to : Enter the string] [Accept: ] Destination Set the e-mail address of the recipient of the status notification, address within 60 characters. ([email protected]) [ : Enter the setting mode] [ : Move from digit to digit] [ to : Enter the string] [Accept: ] PRECAUTIONS • Browser authentication and Password are factory-set to Off and no string, respectively. You should set them as soon as possible. • If you have forgotten your password, set it again using the menu on the main unit. 40 ■ Computer settings Refer to instruction manuals of your computer or wireless LAN PC card to perform the following settings. • Select Ad hoc (for some PC cards, this is Peer-to-Peer Group). • Set the Channel to channel assigned to the projector (in factory reset mode, this is set to 10). For some computers, you cannot set the channel in Ad hoc mode. • Set SSID (for some types of PC card, use Network name instead) as the same as projector's SSID (at factory shipment, this is set to DPJ). • If Encryption and Key are set on the projector, set to the same values. Note: It is imperative that the projector and computer encryption settings are the same. If the settings are different, the encryption may be invalid when sending in the Ad hoc communication mode, so be careful. 41 Operations