Uniden D3098S English Owner's Manual - Page 26

Multi-handset problems A handset says Unavailable. I can't register a new handset. Possible solutions xxMove the handset closer to the base. xxSee if any handset is in Privacy Mode. xxReset the handset (see page 26). xxReset the handset (see page 26). xxSee if you have 12 registered handsets. Answering system problems Possible solutions The answering system does xxMake sure the answering system is on. not work. xxMake sure the base is plugged in. The system won't record messages. xxSee if Record Time is set to Announce Only. xxDelete messages (memory may be full). A handset can't access the xxSee if another handset is using the system. answering system. xxMake sure the phone is in standby. My outgoing message is gone. xxIf there was a power failure, re-record your personal outgoing message. I can't hear the base speaker. xxMake sure call screening is turned on. xxChange the base speaker volume. Messages are incomplete. xxIncrease the Record Time. xxDelete messages (memory may be full). The system keeps recording when I answer on an extension. xxYou may have to change the line mode. Contact Customer Service for instructions. Installing a Line Filter or DSL Filter A telephone line filter or DSL filter prevents services that use the phone line from causing interference on your phone. To get a line filter, contact your service provider or look in an electronics store. Plug the filter into the telephone wall jack and plug the base into the filter. Make a test call to make sure the noise is gone. Liquid Damage CAUTION: If the base is covered in liquid, disconnect the adapter and phone cord from the wall before touching it. If the liquid is only on the exterior housing of the base or handset, wipe it off and use as normal. If you can hear liquid inside the housing: 1. Disconnect all cables and cords and remove all compartment covers. 2. If liquid is leaking from any vent or hole, turn the phone so that vent faces down. If not, place the largest vent face down. 26 - English