Uniden D3098S English Owner's Manual - Page 5

Set Up the Accessory Handset(s) Install and Charge the Battery 1. Unpack all handsets, battery packs, and battery covers. If any handset has the battery cover already attached, press in on the notch and slide the cover down and off. 2. Line up the battery pack connector with the jack inside the handset. (The battery connector will only fit one way.) 3. Push the battery pack connector in until it clicks into place. Tug gently on the wires to make sure the battery pack is securely connected. 4. Place the batter cover and slide it up into place. 5. Use an AC adapter to connect the power jack on each charger to a regular indoor (120V AC) power outlet. 6. Place each handset in a charger with the display facing forward. If the battery icon does not begin cycling through levels, reseat the handset or connect the charger to a different outlet. ##Charge all handsets completely (about 15 hours) before using them. Test the Connection Pick up each handset and press Talk/FLASH. You should hear a dial tone, and the display should say Talk. (Press Talk/FLASH or END/CLEAR again to hang up.) If there is noise or static, see "There's a lot of noise or static on the line" on page 25 for tips on avoiding interference. 5 - English