Uniden D3098S English Owner's Manual - Page 4

Connect the Power and Telephone Cords 1. Connect the base AC adapter to the power jack and the telephone cord to the TEL LINE jack. Route the cords as shown below: For desktop use For wall mount use WALL DESK WALL DESK WALL DESK WALL 2. Plug the AC adapter into a standard 120 V AC power outlet, and connect the telephone cord to a standard telephone wall jack. 3. If you are mounting the phone on the wall, place the mounting slots over the pins on the wall plate, and slide the base down to lock it into place. Test the Connection Pick up the corded handset from the base. You should hear a dial tone and the display on the base should say Talk. When you get a dial tone, make a quick test call. If... Try... the display says Check Tel Line or you checking the connection between the base don't hear a dial tone and the phone jack. you keep hearing a dial tone changing to pulse dialing. Changing from Tone to Pulse Dialing Your phone uses tone dialing by default. If your phone company uses pulse dialing, you need to change your phone's dial mode. 1. Press MENU on the base or Menu/OK on the handset and select Advanced Setup (see p. 10 for using the menus). 2. Select Dial mode, then Pulse. You'll hear a confirmation tone. To send DTMF tones during a call (e.g., for an automated response system), press to temporarily switch to tone dialing. When you hang up, the phone automatically returns to pulse dialing. 4 - English