Uniden OCEANUS DSC English Owners Manual - Page 63

Troubleshooting

Get Uniden OCEANUS DSC PDF manuals and user guides
UPC - 050633500491
View all Uniden OCEANUS DSC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 63 highlights

Troubleshooting If the OCEANUS DSC does not perform to your expectations, try the suggestions listed below. If you cannot get satisfactory results, call the Uniden Technical Support at (800) 586-0409, 8:00 a.m. to 5:00 p.m., Central Standard Time, Monday through Friday. SYMPTOM Won't power On. CAUSE No or low voltage. REMEDY Check for proper voltage getting to the set. When the PTT is pressed - Tx icon comes on and another radio can hear a "click" but no audio is heard. Bad mic element. Send in for repair. While scanning, the A source of noise is Eliminate the source of radio stops on a nearby. the noise or delete the particular channel all channel from the of the time. scanner. There is noise on the receiver that the squelch will not eliminate. An external noise is Either turn off the being generated by offending device or some device. contact that Mfg. Regarding FCC part 15 "unintentional radiator". 60

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
60
If the
OCEANUS DSC
does not perform to your expectations, try the
suggestions listed below.
If you cannot get satisfactory results, call the
Uniden Technical Support at (800) 586-0409, 8:00 a.m. to 5:00 p.m.,
Central Standard Time, Monday through Friday.
Troubleshooting
CAUSE
No or low voltage.
Bad mic element.
A source of noise is
nearby.
An external noise is
being generated by
some device.
SYMPTOM
Won
’
t power On.
When the PTT is
pressed - Tx icon
comes on and
another radio can
hear a
“
click
”
but no
audio is heard.
While scanning, the
radio stops on a
particular channel all
of the time.
There is noise on
the receiver that the
squelch will not
eliminate.
REMEDY
Check for proper voltage
getting to the set.
Send in for repair.
Eliminate the source of
the noise or delete the
channel from the
scanner.
Either turn off the
offending device or
contact that Mfg.
Regarding FCC part 15
“
unintentional radiator
”
.