Vaddio RoboSHOT 30 HDMI User Guide - Page 12

RoboSHOT HDMI Series Cameras CONTROLLING THE CAMERA IR Remote Commander The following functions are accessible with the Vaddio IR remote:  Camera Power On/Off (Toggle on/off same button)  Back Light Compensation (Toggle on/off same button)  Data Screen: Toggle on/off the OSD for the RoboSHOT's IP/MAC Address  Camera Select (the remote can operate 3 cameras (with 3-IR Freq.)  Pan/Tilt and Home controls with Reverse and Std. Pan direction  Pan/Tilt Reset  Auto Focus (Toggle on/off same button)  Zoom In/Out controls Wide & Telephoto  Fast speed controls (W & T)  Slow speed controls (W & T)  Manual Focus On/Off control (Toggle on/off same button)  Near (-) adjustment  Far (+) adjustment  Six (6) pan/tilt/zoom positioning presets (1 through 6)  Preset Set (store)  Preset Reset (clear)  Red LED that indicates IR Transmission and battery level Vaddio IR Remote Commander The IR Remote operational characteristics are as follows:  Preset Activation: IR Remote is limited to executing Presets 1 through 6  Tri-Sync Speed on Preset: If a global Tri-Sync speed is stored in the preset by the user/admin, then that speed is used. If no Tri-Sync speed is assigned, then a default (medium) speed will be used.  Preset Store: IR Remote is limited to positional (PTZ) type presets. To set a preset, position the camera, hold down the Preset Button and touch the one of the preset numbered buttons 1 through 6. Telnet Control Examples The following Telnet* commands are available through the Ethernet Port.  Camera Home  Camera Pan (left, right and speed - real-time operation)  Camera Tilt (up, down and speed - real-time operation)  Camera Zoom (zoom in/out/stop and speed - real-time operation)  Camera Store Preset (Gets or Sets 16 presets with global relative PTZ [Tri-Sync] speed control to destination)  Camera CCU(Gets or sets current image control values, sets in 1 of 3 CCU presets) (AWB or manual w/Red and Blue gain, BLC on/off, Auto Iris or manual with Iris value and Gain, Detail and Chroma)  Camera Standby (Gets or sets standby power mode - camera uses less power in this mode)  Help (displays CLISH syntax)  History (command history)  Network Ping (send ICMP ECHO_REQUEST to network hosts)  Network Settings (Gets MAC address, IP address, Subnet Mask, Gateway and NTP server address)  System Factory Reset  System Reboot  Version (system version information)  Exit (ends Telnet session) *Please see the full and actual Telnet command list at the end of this manual for the actual command set. RoboSHOT HDMI Series Camera Manual - Document Number 342-1001 Rev A Page 12 of 40