Vantec CB-ISATAU2 Manual - Page 25
Installing the SATA/IDE USB 2.0 Adapter to 2.5 PATA IDE Drive
View all Vantec CB-ISATAU2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
7. Installing the SATA/IDE USB 2.0 Adapter to 2.5" (PATA) IDE Drive 1. Since 2.5" IDE drive when connected to the SATA/IDE USB 2.0 Adapter is drawing power from the USB port, you do not need to use the Power Adapter 2. Please follow instruction carefully. If connected wrongly it may damage your drive and adapter 3. Look carefully at the 2.5" IDE drive. You will notice there are two sets of pins on the drive interface. A set with 44 pins (important - there is a pin missing) and another 4 pins. They are often separated by a gap shown 4. The 4 pins are not used 5. Align carefully the 44 pins (note: one hole on the adapter side interface is plug up) on the adapter with the drive's 44 pins. The missing pin MUST align up with the plug up hole. 6. Connect and make sure the interface is securely connected between the drive and the Adapter. 9