Vantec UGT-ST320R User Guide - Page 12
Driver Installation
View all Vantec UGT-ST320R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
your system starts up. If the BIOS doesn't show, please try your controller in another PCI slot. During this (POST) process, the BIOS will show up and indicate the devices attached to it. Driver Installation For Windows® 2000 For New Installation A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the "UGT-ST320R\XP_2003_Vista_2008 32-bit" folder, found on the driver CD, onto a blank floppy disk then follow the directions below. 1. Setup the RAID Array prior to Windows installation. 2. Follow Windows® 2000 installation procedure. 3. At the Windows® 2000 Setup screen, press F6 to install the RAID driver. 4. When prompted, press S to specify the location of the driver. 5. Insert the floppy disk, then press Enter. 6. Select Silicon Image SiI 3x12 SATARaid Controller for Windows 2000, then press Enter. 7. Press Enter again to finish driver installation, then follow the UGT‐ST320R Page 12