Vantec UGT-ST320R User Guide - Page 9

For Existing Hard Drives with Data 1. As the BIOS boots press Ctrl+S or F4 when prompted to enter the RAID BIOS. 2. At the next screen select Create RAID Set, then press Enter. 3. At the next screen select Mirrored then press Enter. 4. Select Manual configuration, then press Enter. 5. Select the Source drive, press Enter. 6. Select the Target drive, press Enter. 7. Enable Disk Copy, select Yes, then press Enter. Note: Enable Disk Copy - Copy current content of source driver to mirror drive; Disable Disk Copy - RAID 1 set formed must be repartitioned and reformatted to guarantee the consistency in their contents. 8. Press Ctrl+E to exit the BIOS. 9. When asked Are you sure to exit(Y/N)?, press Y to exit and reboot. Note: If during boot the RAID BIOS reports an RAID1 set is in Rebuild status, The rebuild will continue after boot sequence is complete, disregard the message, continue booting, and let the Mirror rebuild. UGT‐ST320R Page 9