Vantec UGT-ST320R User Guide - Page 15

A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the UGT-ST320R\XP_2003_Vista_2008 64-bit" folder, found on the driver CD, onto a blank floppy disk then follow the directions below. 1. Setup the RAID Array prior to Windows installation. 2. Follow Microsoft's Windows installation procedure. 3. At the Windows Setup screen, press F6 to install the RAID driver. 4. When prompted, press S to specify the location of the driver. 5. Inset the floppy disk, then press Enter. 6. Select Silicon Image SiI 3x12 SATARaid Controller (64-bit Extended) or Silicon Image SiI 3x12 SATARaid Controller (Itanium), then press Enter. 7. Press Enter to finish driver installation, then follow the on-screen instructions to complete the Windows installation. For An Existing Installation 1. Setup the RAID Array prior to driver installation and boot up to Windows. 2. At the Found New Hardware Wizard, select No, not this time, UGT‐ST320R Page 15