Viking VGSO100SS Installation Instructions - Page 9

Door Removal (30"W.) Installation (30"W.) 1 NOTICE DO NOT use the handle or oven door to lift the oven. Remove door before installation to ensure that it is not used to lift the unit. DO NOT lift or carry the door by the handle. Removing the door must be done by your dealer, a qualified licensed plumber, or certified gas installer. Remove wooden brace on front of pallet. 2 3 1 2 Open door completely. Place pin in pin hole. Note: Two pins included. 4 2 2 1 Remove hinge trim screws. Take off hinge trim. 5 Close until pins stop door. Lift door up and out. Note: Do not lift door using handle. 16 Connecting Gas & Electrical (30"W.) DANGER Gas leak hazard. To avoid risk of personal injury or death; leak testing of the appliance must be conducted according to the manufacturer's instructions. Before placing appliance in operation, always check for gas leaks with soapy water solution. • DO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS. 1 WARNING Electrical shock hazard. To avoid the risk of electrical shock, personal injury or death; verify your appliance has been properly grounded in accordance with local codes or in absence of codes, with the National Electrical Code (NEC). ANSI/NFPA 70-latest edition. Note: Refer to "Electrical & Gas Requirements" section for proper installation information. Connect gas and electrical. Before placing appliance in operation, always check for gas leaks. This must be performed by your dealer, a qualified licensed plumber, or gas service company. 17