Weber Genesis Jr LP Owner Manual - Page 20
Install, holders, control, panel, burner, knobs, swing, table
View all Weber Genesis Jr LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Step 21 Install lid You will need: lid, two hinge pins and two hair pin cotters Set the lid in place from the rear of the barbecue. Close and align the hinge at the rear. Insert hinge pins from the outside through the hinge. Insert hair pin cotters into the small holes in the hinge pins. Fig= Hair pin cotter Step 23 Install swing table You will need: swing table, hinge support, support rod, spacer, rod cover, 10-24 x 1/2 screw, 10-24 nut, star washer, support rod holder, and a screwdriver. Push the support rod into the lower support bracket. Figure 28 (a). Slide all the way in, so the rod is inside the locking tab. Figure 28 (b). The rod should swing freely inside the locking tab. Figure 28 (c). Hinge pin Figure 26 Step 22 Install tool holders, control panel and burner knobs You will need: three tool holders, control panel (with control panel push-in buttons) and two burner control knobs. Hook the tool holders over the frame rail. Figure 27. Set the control panel in place over both frame braces. Place your thumbs over the control panel push-in buttons, and push them into the frame brace until they snap into place. Figure 27 (a). Push on the two burner control knobs. Figure 27 (b). Hole in frame brace (a) c=) Tool holders Figure 27 Control panel push-in buttons (b)