Weider 8530 User Manual - Page 5

ASSEMBLY Before beginning assembly, carefully read the following information and instructions: • Place all parts of the home gym system in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. • Assembly is divided into five stages: 1) frame assembly, 2) press and butterfly arm assembly, 3) cable and pulley assembly, 4) seat and backrest assembly, and 5) VKR assembly. The hardware for each stage is packaged separately. • Wait until you begin each assembly stage to open the parts bag labeled for that assembly stage. • For help identifying the small parts used in assembly, use the PART IDENTIFICATION CHART located in the center of this manual. Note: Some small parts may have been preattached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached. • As you assemble the home gym system, be sure that all parts are oriented as shown in the drawings. • Tighten all parts as you assemble them, unless instructed to do otherwise. THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY: • Two adjustable wrenches • One standard screwdriver • One phillips screwdriver • One rubber mallet • Lubricant, such as grease or petroleum jelly, and soapy water will also be needed. Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. FRAME ASSEMBLY 1. Before beginning assembly, be sure that you have read and understand the information in the box above. Press a 2" Inner Cap (27) into the indicated end of the Stabilizer (5). Press 2" Outer Caps (51) onto the other two locations on the Stabilizer. Press a 2" Inner Cap into the end of the Base (4). Insert four 5/16" x 2 1/2" Carriage Bolts (1) up through the Stabilizer (5). Attach the Base (4) to the Stabilizer (5) with two 5/16" x 2 3/4" Bolts (11), two 5/16" Flat Washers (8), and two 5/16" Nylon Locknuts (3). Do not tighten the Nylon Locknuts yet. Slide the VKR Upright (74) and the Squat Arm Upright (56) onto the 5/16" x 2 1/2" Carriage Bolts (1) in the Stabilizer (5). The high side of the brackets on the VKR Upright and Squat Arm Upright should be on the side shown. Hand-tighten four 5/16" Nylon Locknuts (3) onto the Carriage Bolts. Do not tighten the Nylon Locknuts yet. 1 56 High Side 74 3 27 51 11 8 3 5 1 51 1 3 4 27 5