Weider 8530 User Manual - Page 9

ARM ASSEMBLY 11. Lubricate both axles on the Top Frame (55). Slide the Right Arm (48) onto the right axle. Be careful not to confuse the Right Arm with the Left Arm (47); note the position of the "V" Pulley (50) to identify the Right Arm. Be sure that the upper end of the Right Arm is behind the indicated bracket on the Top Frame (55). Tap two 1" Retainers (69) and a 1" Round Cover Cap (70) onto the axle. Be sure that the teeth on the Retainers bend toward the Round Cover Cap, as shown in the inset drawing. Attach the Left Arm (47) in the same manner. Press 1 3/4" Inner Caps (44) into the lower ends of the Left and Right Arms (47, 48). Wet the lower end of each Arm with soapy water. Slide a 10" Pad (45) onto the lower end of each Arm. 11 50 44 45 55 Bracket 47 Axle- Lubricate 69 70 45 48 44 55-Axle 69 70 12. Press two 1" x 2" Inner Caps (87) into the indicated end of the Squat Arm (84). Attach the Squat Arm (84) to the VKR Upright (74) with a 3/8" x 5 1/2" Bolt (93) and a 3/8" Nylon Locknut (21). Be sure that the indicated bracket is pointing down as shown. Wet the ends of the Squat Arm (84) with soapy water. Slide the two Squat Arm Pads (85) onto the Squat Arm. Attach a Handle (82) to one side of the Squat Arm (84) with a 5/16" x 2 1/2" Bolt (22), two 5/16" Flat Washers (8), a 1/2" x 17/32" Spacer (91), and a 5/16" Nylon Locknut (3). Wet the Handle (82) with soapy water. Slide a 5" Plastic Grip (83) onto the Handle. Press a 1" Round Inner Cap (49) into the other end of the Handle. Assemble another Handle (82) to the other side of the Squat Arm (84) in the same manner. 12 21 74 83 22 85 82 8 3 Bracket 49 87 91 82 85 84 93 9