Weider 8530 User Manual - Page 6

2. Insert two 5/16" x 2 1/2" Carriage Bolts (1) up through the Base (4). 2 27 Slide the Front Upright (42) onto the 5/16" x 2 1/2" Carriage Bolts (1) in the Base (4). Hand-tighten a 5/16" Nylon Locknut (3) onto each Carriage Bolt. Do not tighten the Nylon Locknuts yet. 27 56 Press a 1" Inner Cap (6) into the Front 74 Upright (42). Press a 2" Inner Cap (27) into the Squat Upright (56). Press a 2" Inner Cap into the VKR Upright (74). 42 FRAME ASSEMBLY 6 3 4 3. Press a 2" Inner Cap (27) into the end of the Top Frame (55). Press a 1 3/4" Inner Cap (44) into each end of the crossbar on the Top Frame. Press two Inner Caps (96) into the top of the crossbar. Attach the Top Frame (55) to the Front Upright (42) with two 5/16" x 2 3/4" Bolts (11), two 5/16" Flat Washers (8), and two 5/16" Nylon Locknuts (3). Attach the Top Frame (55) to the VKR Upright (74) and the Squat Upright (56) with two 5/16" x 2 3/4" Bolts (11) and two 5/16" Nylon Locknuts (3). Tighten all of the 5/16" Nylon Locknuts (3) used in steps 1-3. 4. Set two Weight Bumpers (19) on the bracket on the Base (4) as shown. Set two Weight Bumpers (19) on the bracket on the Stabilizer (5). Stack eight Weights (25) onto each set of Weight Bumpers (19). Be sure that the pin grooves are all on the same side of each stack of Weights. Be careful not to tip either stack of Weights (25) until step 6 is complete. 3 27 11 74 1 11 55 3 8 96 44 Crossbar 44 3 56 42 4 Pin Grooves 25 19 5-Bracket 25 19 4-Bracket Pin Grooves 6