Weider 9150 Uk Manual - Page 11
Locate the Low Cable 69
View all Weider 9150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
16. Route the High Cable (23) up through the Top Frame (55), around the 115mm Pulley (74), and back down through the Top Frame. Attach the Pulley inside the Top Frame with an M10 x 75mm Bolt (76), two 17.5mm Spacers (77), two M10 Washers (9), and an M10 Nylon Locknut (21). 16 55 77 9 21 23 74 76 77 9 17. Attach the High Cable (23) to the "U"-bracket (57) 17 with an M8 Washer (70) and an M8 Nylon Locknut (3). Note: Do not completely tighten 23 the Nylon Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset drawing. 70 66 57 3 Attach the "U"-bracket (57) to the Weight Tube (63) with an M8 x 45mm Bolt (66) and an M8 63 Nylon Locknut (3). Do not overtighten the Nylon Locknut; the Weight Tube must be able to pivot easily. 18. Locate the Low Cable (69), which has a ball on 18 each end. Rest the Cable in the bracket on the Base (4). Attach a 90mm Pulley (15) inside the bracket with an M10 x 45mm Bolt (88) and an M10 Nylon Locknut (21). 15 4 21 23 3 88 69 19. Wrap the Low Cable (69) around a 90mm Pulley (15). Attach the Pulley and a pair of Pulley Covers (40) to the bottom hole in the Front Upright (42) with an M10 x 110mm Bolt (64), an M10 Washer (9), and an M10 Nylon Locknut (21). Be sure the large tabs on the Pulley Covers are on the side shown. 19 42 21 9 69 40 15 64 Large 40 Tab 11