Weider 9150 Uk Manual - Page 9
Cable Assembly
View all Weider 9150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
9. Press a 50mm Square Inner Cap (44) into the 9 end of the Right Butterfly Arm (48). Press a Sleeve (89) into the Right Butterfly Arm. Wet the lower end of the Right Butterfly Arm (48) with soapy water. Slide a Large Foam Pad (45) onto the Right Butterfly Arm. Repeat this step with the Left Butterfly Arm (47). 10. Lubricate the axles on the Top Frame (55). Orient 10 the Right Butterfly Arm (48) as shown and slide it onto the right axle. Be sure the Butterfly Arm is behind the bracket on the Top Frame. Have a second person secure the Right Butterfly Arm (48) to the axle with two 25mm Retainers (68) and a 25mm Cover Cap (65). Note: Place the Retainers on top of the inverted Cover Cap, as shown in the inset drawing. Make sure the teeth on the Retainers bend toward the Cover Cap. Gently tap the Cover Cap onto the axle. Repeat this step with the Left Butterfly Arm (47). 89 47 48 45 44 45 44 55 Bracket 47 Lubricate Axle 48 68 65 Cable Assembly 11 11. For cable identification and routing during steps 11 to 25, refer to the CABLE DIAGRAMS on page 20. Do not overtighten the bolts and locknuts that secure the pulleys; the pulleys must be able to rotate freely. Locate the High Cable (23), which has a ball on one end and a bolt on the other. Route the bolt end of the Cable up through the Top Frame (55) and around a "V"-Pulley (6). Attach the Pulley inside the Top Frame with an M10 x 75mm Bolt (76), two 12.5mm Spacers (82), two M10 Washers (9), and an M10 Nylon Locknut (21). 9 Axle 68 65 23 6 55 76 82 9 82 21 9