Weider 9150 Uk Manual - Page 6
Frame Assembly
View all Weider 9150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
FRAME ASSEMBLY 1 1. Before beginning assembly, make sure you have read and understood the information on page 5. This introduction will save you 5 more time than it takes to read it. 73 Small Holes 21 73 Press a 40mm x 60mm Inner Cap (27) into the end of the Base (4). Press two 40mm x 60mm Outer Caps (73) onto the ends of the Stabiliser (5). Insert four M10 x 55mm Carriage Bolts (1) up Indents 1 4 through the Base (4) and the Stabiliser (5). Rest the Base and the Stabiliser flat on the floor. Note: Make sure that the indented holes in the Stabilizer are on the bottom. Note that the 4 indicated holes are smaller than the holes on the other side of the Stabilizer. 1 Attach the Base (4) to the Stabiliser (5) with the indicated M10 x 55mm Carriage Bolts (1) and two 27 M10 Nylon Locknuts (21). Do not tighten the Locknuts yet. 2 2. Press the 25mm Square Inner Cap (86) into the Front Upright (42). Attach the Front Upright (42) to the Base (4) with the two M10 x 55mm Carriage Bolts (1) and two M10 Nylon Locknuts (21). Do not tighten the Locknuts yet. 42 21 4 1 86 21 6