Weider Cjxt3 Master Trainer User Manual - Page 11

f 3. Attach the Backrest (41) to the Front Upright (42) with two 1/4" x 2 1/2" Screws (43) and 1/4" Flat 23 Washers (10). - . . ...... 3 10 41 24. Press a 1 1/2" Inner Cap (32) into the Seat Frame (36). 24 42 13 Insert a 1/4" x 2" Carriage Bolt (38) into the center of each Seat Plate (37). Attach the Seat Plates to the Seat (13) with four 1/4" x 1/2" Screws (103). Insert the two 1/4" x 2" Carriage Bolts (38) into the Seat Frame (36). Make sure that the Seat (13) is turned so the wide end is towards the 1 1/2" Inner Cap (32). Tighten two 1/4" Nylon Locknuts (7) with 1/4" Flat Washers (10) onto the Carriage Bolts. . , Wide End 37 , 38 ' . % 103 , 37 32 . ci 10 ' e,.< % 36 25. Press a 1 1/2" Inner Cap (32) into the Leg Lever (29). Lubricate a 5/16" x 2 1/4" Bolt (33). Attach the Leg Lever (29) to the Seat Frame (36) with the Bolt and a 5/16" Nylon Locknut (3). Do not overtighten the Nylon Locknut; the Leg Lever must be able to pivot freely. 25 fs) 7 t % 3 36 33-Lubricate 29 32 26. Set the bracket on the Seat Frame (36) onto the indicated pins on the Front Upright (42). Attach the Seat Frame with a 5/16" x 2 3/4" Carriage Bolt (14) and the Seat Knob (40). Press 3/4" Round Inner Caps (34) into the ends of the 13 1/2" Pad Tube (28) and the 13" Pad Tube (31). Insert the 13 1/2" Pad Tube (28) into the Seat Frame (36). Slide a 6" Pad (30) onto each end of the Pad Tube. 26 40 4( 36 .... -N, . 14 • 42 Pin 30 Insert the 13" Pad Tube (31) into the Leg Lever (29). Slide a 5 1/2" Pad (50) onto each end of the Pad Tube. 11 28 34 29 50 .,, 30 50