Weider Flex 8960 Uk Manual - Page 12
Locate the two Short Cables 33.
View all Weider Flex 8960 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
23. Have a second person lift the Top Weight (not 23 shown) to create slack in the Long Cable (80). Slide one end of the Cable through the Swivel Arm (22). Make sure the Cable is on the indi- cated side of the rod in the Swivel Arm. Wrap the Long Cable (80) around a Large Pulley (28). Attach the Pulley and a Arm Pulley Cover (87) to the Swivel Arm (22) with an M10 x 45mm Bolt (2) and an M10 Nylon Locknut (76). 24. Locate the Bench Cable (32). It has three ends, 24 two that are the same length, and a third that is shorter. Route the short end of the Bench Cable (32) through the hole in the Front Leg (6), and attach it inside the slot in the Leg Lever (7) with an M10 x 62mm Bolt (63), two M10 Washers (75), and an M10 Nylon Locknut (76). 2 Rod 22 28 80 76 87 6 32 75 76 7 63 75 25. Wrap the Bench Cable (32) under a Large Pulley (28). Attach the Pulley and a pair of Pulley Covers (29) inside the hole in the Front Leg (6) with an M10 x 65mm Bolt (79), two 8mm Spacers (52), two M10 Washers (75), and an M10 Nylon Locknut (76). Make sure that the small tabs on the Pulley Covers are on the bottom. Slide the two free ends of the Bench Cable (32) onto the eyebolt welded to the bottom of the Bench Frame (5). 26. Locate the two Short Cables (33). Wrap a Short Cable over a Large Pulley (28). Attach the Pulley and a pair of Pulley Covers (29) to a Pulley Housing (21) with an M10 x 50mm Bolt (71) and an M10 Nylon Locknut (76). Make sure that the small tabs on the Pulley Covers are on the bottom. Repeat this step with the other Short Cable (33). 25 5 Eyebolt 32 29 Small Tab 29 28 52 76 75 26 6 75 79 52 76 29 21 71 Small 29 Tab 28 33 12