Weider Flex 8960 Uk Manual - Page 8
top of the Front Leg 6. Press the Front Leg Foot
View all Weider Flex 8960 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
8. Press two 40mm x 50mm Inner Caps (41) into the ends of the Cross Frame (11). Orient the Cross Frame (11) as shown, with the welded tube near the top. Attach the Cross Frame to the Upright (3) with two M10 x 105mm Carriage Bolts (73), two M10 Washers (75), and two M10 Nylon Locknuts (76). 8 76 75 Welded Tube 75 11 41 41 3 73 9. Press a 40mm x 50mm Inner Cap (41) into the 9 top of the Front Leg (6). Press the Front Leg Foot (27) onto the bottom of the Front Leg. Note that the front of the Front Leg Foot is taller and 41 slants more than the back. Press a 40mm x 50mm Inner Cap (41) into the end of the Bench Frame (5). Attach the Bench Frame (5) to the Front Leg (6) with two M10 x 57mm Carriage Bolts (61) and two M10 Nylon Locknuts (76). Do not tighten the Locknuts yet. 5 41 76 6 61 Back 27 10. Lubricate the M10 x 80mm Bolt (66) with grease. 10 Attach the Bench Frame (5) to the Upright (3) with the Bolt and an M10 Nylon Locknut (76) at the indicated hole. Do not overtighten the Locknut; the Bench Frame must be able to pivot easily. Tighten the Knob (30) into the Upright (3) and the Bench Frame (5). 3 30 Lubricate 66 Hole 76 5 11. Attach the Leg Lever Bumper (55) to the Front 11 Leg (6) with the M4 x 25mm Screw (56). Press two 45mm Square Inner Caps (42) into the ends of the Leg Lever (7). Lubricate an M10 x 70mm Bolt (64) with grease. Attach the Leg Lever (7) to the Front Leg (6) with the Bolt and an M10 Nylon Locknut (76). Do not overtighten the Locknut; the Leg Lever must be able to pivot easily. 8 64 6 Lubricate 42 76 7 55 56 42