Weider Flex 8960 Uk Manual - Page 7
Tighten the two M10 Nylon Locknuts 76 used
View all Weider Flex 8960 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
5. Slide the nine Weights (35) onto the Weight Guides (8) with the pin grooves on the side shown. Press the Weight Tube Bumper (18) into the Weight Tube (44). Insert the Weight Tube into the stack of Weights (35). Lubricate the indicated holes in the Top Weight (86) with grease. Slide the Top Weight onto the Weight Guides (8). Make sure the pin on the Weight Tube (44) rests in the groove on the bottom of the Top Weight. 5 Lubricate 8 86 Pin 44 18 35 6. Press a 45mm Square Inner Cap (42) into the Top Frame (9). Attach the Top Frame (9) to the Top Upright (4) with an M10 x 65mm Bolt (79), an M10 Split Washer (43), and an M10 Large Washer (90). Attach the Top Frame (9) to the Weight Guides (8) with an M10 x 155mm Bolt (85), two M10 Washers (75), and an M10 Nylon Locknut (76). Tighten the two M10 Nylon Locknuts (76) used in step 2. 6 42 75 85 8 Pin Groove 79 43 90 9 76 75 4 7. Press two 38mm Round Inner Caps (40) into the ends of the Crossbar (10). Attach the two Eyebolts (34) to the Crossbar (10) with two M8 Washers (59) and two M8 Nylon Locknuts (65). Do not overtighten the Locknuts; the Eyebolts must be able to rotate freely. Attach the Crossbar (10) to the Top Frame (9) with two M10 x 56mm Bolts (70), two M10 Small Washers (91), and two M10 Nylon Locknuts (76). Be sure the Crossbar is attached as shown in the inset drawing. If the ends point away from the Top Frame, turn the Crossbar around and reattach it. 7 9 76 65 59 34 40 10 91 65 59 40 34 70 10 9 7