Weider Pro 4100 English Manual - Page 16

37. Remove the preattached 3 1/2" Pulley (not 37 shown) from the "U"-Bracket (85). Attach the end of the Leg Lever Cable (96) to the other "U"-Bracket (85) with a 1/4" Washer (35) and a 1/4" Nylon Locknut (65). Note: Do not completely tighten the Nylon Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset drawing. 38. Locate the Low Cable (47). Route the small ball 38 on the Cable through the cage on the Leg Press Frame (30). Attach a 3 1/2" Pulley (38) inside the Leg Press Frame (30) with a 3/8" x 2 3/4" Bolt (81), two 3/8" Washers (75), two 1/2" Spacers (34), and a 3/8" Nylon Locknut (70). 96 35 85 65 38 34 81 75 96 65 30 34 70 75 Cage 47 39. Route the Low Cable (47) through the Left Leg 39 (36) and the Left Upright (7). Attach a 3 1/2" Pulley (38) inside the Upright with a 3/8" x 2 3/4" Bolt (81), two 3/8" Washers (75), two 1/2" Spacers (34), and a 3/8" Nylon Locknut (70). 34 38 75 70 34 75 81 7 47 36 40. Wrap the Low Cable (47) around a 3 1/2" Pulley 40 (38). Attach the Pulley and a Cable Trap (91) to the lower set of holes in the indicated "U"-Bracket (85) with a 3/8" x 2" Bolt (62) and a 3/8" Nylon Locknut (70). Be sure the Cable Trap is turned to hold the Cable in the groove of the Pulley. 85 62 70 91 38 47 16